Overview
The Rollerblade Macroblade Cuff Buckles (or top buckles) with straps serve as replacements to match those found on the popular Rollerblade Macroblade Series (80, 90, 100 and 110). They are standard cuff buckles (SCB) so they are compatible with other brands and models using the same mounting method. Sold in pairs with buckles, straps, receivers, rivets, and hardware to install.
Rivets are included but a rivet tool is not. Rivet tools can be found for approximately $5 at the hardware store. Drilling or cutting away rivets to remove your old buckle is not overly difficult but may be necessary. If not wishing to purchase a tool, using screws from another buckle set is possible.
Standard Cuff Buckles (SCB). Three-point mount. Buckle mounts to the outside of the boot at two points 1.5cm apart. The receiver (or receptor) where the strap feeds into mounts on the inside of the boot at one point. SCB buckles are compatible across different brands and models using this same mounting method.
Specifications
| OVERVIEW | |
|---|---|
| Includes | (2) Buckles Straps (2) Buckle Receivers (4) Rivets (4) Washers for mounting |
| Compatibility | 2013 and newer Macroblade 80, 84, 90, 100, and 110 (Men's or Women's) |
| General Compatibility Note | This buckle kit is attached to the boots using the 3-point buckle attachment system. This means the buckle is attached to the boot using a single rivet point, and two rivet points on the strap, allowing this buckle to be compatible with any similar buckle/strap setup. |
| Strap Length | 20cm |
